用化学法出产磨砂亚新（中国）官网的工艺办法，其过程是：

　　（1）清洗烘干：主要对要将出产磨砂亚新（中国）官网的平板亚新（中国）官网用水进行清洗，去除灰尘、污渍，然后烘干；

　　（2）吊装：将清洗烘干后的平板亚新（中国）官网装入吊装架上，吊装架与亚新（中国）官网相接触的部分用齿形橡胶支架垫起，是立式排放，亚新（中国）官网与亚新（中国）官网之间相距一定的距离，用吊车吊起；

　　（3）腐蚀：用吊车将平板亚新（中国）官网连同吊装架一同浸入腐蚀箱中，选用惯例腐蚀液浸没亚新（中国）官网，腐蚀时刻5-10分钟，用吊车吊起后，淋掉残液；

　　（4）软化：淋掉残液后，磨砂亚新（中国）官网上面附着一层残留物，放入软化箱中软化，选用惯例软化液浸没亚新（中国）官网，软化时刻1－2分钟，去掉残留物；

　　（5）清洗：因为腐蚀与软化使磨砂亚新（中国）官网体带有许多化学物质，所以有必要清洗，把磨砂u型亚新（中国）官网设计把亚新（中国）官网放入冲洗机的滑道上，滑道带动磨砂亚新（中国）官网进入清洗机，清洗机一边喷入清水，一边转动毛刷，当磨砂亚新（中国）官网被清洗机滑道带出清洗机后，磨砂亚新（中国）官网清洗完毕；

　　（6）清洗后的磨砂亚新（中国）官网放入烘干室烘干，即成单面或双面磨砂亚新（中国）官网。

　　磨砂亚新（中国）官网表面粗糙，使光线产生漫反射透光而不透视：光线通过磨砂亚新（中国）官网被反射后向四面八方射出去在（因为磨砂亚新（中国）官网表面不是光滑的平面，使光产生了漫反射），折射到视网膜上已经是不完整的像，于是就看不见亚新（中国）官网背后的东西了。它可以使室内光线柔和而不刺目。

The process of producing frosted glass by chemical method is as follows: (1) cleaning and drying: cleaning the flat glass with water, removing dust and stains, and then drying; (2) lifting: the cleaned and dried flat glass is put into the lifting frame. The part of the lifting frame that comes into contact with the glass is supported by a toothed rubber support, which is vertical drainage. The distance between the glass and the glass is a certain distance, and is lifted by a crane; (3) corrosion: The flat glass is immersed into the corrosion box together with the lifting frame by a crane, and the glass is immersed in the conventional corrosion solution for 5-10 minutes, after lifting by a crane, the residual liquid is leached off; (4) softening: After the residual liquid is leached off, frosted glass with a layer of residue attached to the top, put into the softening box to soften, choose the usual softening solution to soak the glass, softening time 1-2 minutes, remove the residue; (5) cleaning: Because of corrosion and softening of the frosted glass body with a lot of chemicals, so it is necessary to clean, put the frosted u glass design glass into the washing machine on the slide, slide drive frosted glass into the washing machine, when the frosted glass is taken out of the washing machine, the frosted glass is cleaned; (6) the frosted glass after cleaning is put into the drying room to dry, that is to say, the frosted glass becomes single side or double side frosted glass. The surface of frosted glass is rough, so that light is diffused without penetration: light is reflected through frosted glass and then shot out in all directions (because frosted glass is not a smooth surface, so that light is diffused) , refracted on the Retina is an incomplete image, so you can't see what's behind the glass. It can make indoor light soft and not harsh.